Jump to content

7 inch senko mold.jpg

mark poulson

By mark poulson

 Share

This is my 7" Senko mold.  Any more cavities, and I get incomplete fills.  The duct tape is to fill voids in the mold halves when they're clamped shut, because the POP and epoxy sealer are a little thicker than the 3/4" mold frame, and the tape keeps the plastic from squirting out into the next cavity when I hold pressure for a ten count.

 Share

Recommended Comments

jonister

Thats an awesome POP mold! How does it gas though, or is it injected? Your motivating me to give the soft plastic thing another go. Last time i did it, i didnt seal my mold- which does not work too good 

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
×
  • Create New...
Top