Weight-Forward Spinners From Scratch
By diemai
- 1,859 views
- View diemai's images
To fix and position the front wire shaft reliably to the brass weight I've furnished a little groove with my "Dremel" cutting wheel and extended it lengthwise a bit with a small 1,5mm router bit .
The shorter tag end of the front shaft's open wire loop is bent and pulled back into that groove(after having connected the rear spinner shaft)with pliers , snipped off and ground flush to the brass drum's circumferrence .
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.