Wire coils for soft tails
By BruceKY
- 1,042 views
- View BruceKY's images
Not something you will want to make hundreds of. Kind of hard to describe exactly how I do it, but I will try. It is easier than it sounds, especially with smaller gauge wire. Try to find wire that is soft not spring tempered. It will make things a lot easier. Bicycle spokes are good for this. I use wire from .025" to .060"
I wrap the wire around the last four or five threads on a bolt. Use a smaller bolt than the coil you want to make because it will spring out some. Take the coil off of the bolt and hold it with round nose pliers right up the center of the coil then continue bending the tag end of the wire to center. Next bend the tag end at the center of the coil so that it sticks strait out the central axis of the coil. Finish by making a hook shaped bend on the Tag end of the wire. Trim each end with wire cutters or a cut-off wheel on a dremel tool for thick wire.
I use my dremel tool with a 1/16 bit to make two holes in the tail of the lure right next to each other then carefully remove the material between them to make a slot for the
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.