Leaderboard

https://www.facebook.com/FishingStencils/ i have not bought any from them, but they look great

Great info thanks

If you guys need/want I actually have a set of these I can try in molds to see if they will fit. I can't promise they will fit and I do not have them to sell but I can check for fit. If you want/need to know just drop us an email with the mold number and I will check. The sizes I have are 3/0, 4/0, & 5/0. JB

I've found texture and pattern sheet stencils on Ebay, Amazon, AliExpress, Spraygunner and Coast Airbrush. If you want to make your own for a specific bait, check out Dakota Lakes Tackle on Youtube. He shows how to make vacuum stencils pretty easy. I find the blank stencil material at Hobby Lobby. Cut an appropriate size piece of blank stencil, place over the bait on the vacuum bed, heat with a heat gun until softened and kind of melty, then turn on the vac and suck the softened stencil material down around the bait. Once cooled for 30 secs, remove the stencil from the bait and cut in your pattern or design. I will make extra stencil molds of a bait to cut up to make masks for certain parts of the bait. I cut out the face and gill plate, and also the pec fin. These cut out pieces are your masks. I place a small piece of doubled over painters tape on the inside of the mask to hold in place on the bait. Then place my scale netting over and spray. Heat set the paint and remove the stencils or masks. The mask keeps the scale pattern from appearing on the face, gills and pec fin. Then you can use the piece of stencil you cut the pec fin out of and use it to mask the rest of the bait when painting the pec fin and keep things looking clean. The mesh material can be found at Walmart, Hobby Lobby and your local fabric store. Fabric store will have the largest selection, search for "Tulle". I use the knitting or embroidery hoops to hold the mesh tight and place over the bait to spray thru. Make sure any stencil is as tight to the bait as possible to keep overspray and bleeding to a min. Lower spray pressures help also. Hope this helps...

I am on a pretty tight retirement budget and any time I can save a bit, i do it. Want the lures to work right, tho. Thanks folks, Arne.

I use a crane swivel and a split ring. Since the crane swivel has two loose rings at both ends, I believe that is what you need to let the blade swivel. Similar to bearing swivels on a spinnerbait. If you use a wire form with a loop coming out of the nose of the horse head, it will not rotate or swivel. It just may rock from side to side as it falls down the water column. I would strongly suggest using the crane swivel.

Harbor freight has them. Think they were $4 last fall. Arne.