Leaderboard

I’m impatient too. I heat my injectors and block up with a propane torch. Just keep it moving and while your plastic heats you can warm these up. Some times I use a griddle on HI.

Yeah. I guess I was just a little impatient. With winter setting in here in New England, I actually throw my molds and injector into the oven for a few minutes. I think the major culprit might be the blending block. It's thick and heavy so it probably takes a little longer to heat it up. I always lube my Orings before I start. I use either worm oil or WD 40. Reminds me...I'm running low on worm oil. I've got an entire winter ahead of me to figure out the learning curve of the dual injector. Thanks gang for the comebacks.

This little worm is only 4.25” but spent some time looking around and is the closest I saw. Curly tail looks a little different but close may be the best you can do. https://www.lurepartsonline.com/6920-19-LureCraft-4-1-4-Ring-Worm-4-Cav.-2-Pc.-Alum.-Injection-Molds

I got some actual knobs that were a 1/4-20 thread to use.