Leaderboard

There is a way to pull and shoot until all your plastic is gone with dual injectors and that’s with a dual presto pot setup with automatic stirrers. You will still have to clear your blending block after you demold but the twin injectors you can put back in the hot plastic and draw and shoot and the plastic will stay fluid. You purge back into the pots and stick the nozzles back in the hot plastic. Just pull more plastic when ready. It takes quite a bit more than a few ounces of plastic to get two presto pots going though. Leonard Smith put mine together with PID thermostat controllers for the pots. That was quite a few years ago and not sure if anything like that is available now.

I heat, inject, purge injector & block, wait 2 minutes, demold & then do the whole process over again. I've thought about a hot plate myself but have never went through with it simply because 99% of the time i work in 4 ounce batches for a single color bait or 4 ounces of each color for a laminate.

If you have lead sprue cutters you can just pour the heads with no pins, and the cut small nibs off flush when you're cutting off the sprues. The fish won't care.