Dearmitt1976

Here are some pics

what temp were you injecting at if i may ask pureactionbaits?

i will try i was only holding pressure for 5-10.

im getting voids about 80% of the time and micro bubbles when injecting this mold. ive shot it at 330, 335, 340, 345 and 350. i dont stir plastic till after the chemical reaction. i use bait junkys plastinol. has anyone had problems with this mold 717 craw mold from bts.

yea that one is awesome. It is dead on with the flappin hog but the kreature bait looks like this

Does anyone sell a mold that resembles the yamamoto kreature bait?

Anyone have a good recipe for emerald shiner color? Thank you for your help.

I inject the plastic and 325 not 225 just a typo. I'm using new plastic as well

Here is a picture of the mold.

I tried shooting again using temp of 225-230 and still getting unfinished rings. My brush hog and craw completed good during same shootings.

Thank you guys, I'm gonna try again tomorrow with your suggestions and see what I get.

Good call monte, I picked some of that up and hope to get it poured on Thursday.

I recently purchased a ring swimbait mold and I'm having issues with the ring not completely filling, the always have little chunks out of the rings. I inject it with two other molds and have positioned it first, second and third and have had no issues with the other molds. Any suggestions on what could be causing this? My plastic is always poured at 350. Thanks in advanced for any help.

Is it gold or silver? I think it's gold but depending on the angle it can look silver. Is there both in there?

Thanks guys I will try this.