Search the Community
Showing results for tags 'primer'.
Found 3 results
-
I am having some problems with the primer not adhesion to the wood after sealing the bait, is there some other preparation after the bait is sealed before applying the primer paint ? I usually I sand down the bait sealer than I wipe it with a damp cloth ad now I also dry the bait in a electric oven to 90 degrees I did switch primer paint in the past i used white rust-oleum primer, now I use Zinsser prime which I really like Any suggestion welcome Thanks Gino
-
I use Rustoleum 2x primer, are there better primer than Rustoleum, or what about Krylon and Kilz Thanks Gino
-
I have poured some Alumilite RC-3 test lures, tried foam but didn't find it best for my purpose. I poured, did very minor flash removal around wire through, washed in soap and water, waited a day or so before painting and base coated with white createx. Paint did not stick well. I have read in the forums that you can spray createx directly to RC-3 Wash with soap and water. Run through dish washer. Soak in boiling soapy water Wipe with denatured alchol. sand wait 5 days before painting I am willing to do what it takes but these will be semi mass produced and need to be good. Clear coat will most likely be etex. I am a bit confused as to what I should do or what I didn't do. From you guys that have used a lot of RC-3, what is your Procedure?
