Search the Community
Showing results for tags 'silicon'.
Found 1 result
-
Hi all, In the past I tried some of this stuff (feather lite) yet the results were pretty good I hade some issues with the bubbles on the surface, I was expecting a clear result but it seems there is a reaction between the components because the mixture expands a little bit (by far less than foam) which I think involves some heat resulting in air traped bubbles (don't know if this happens inside the body as well) So for obtaining a shiny surface I am considering the following things: - the room temperature, I don't remember if it was the one indicated in the tehnical buletin - pressure casting - can someone help me on this...how it is done? - vibrating table - I think maybe putting the mold on such a table may cause the bubbles to rise Any other ideas might help, please feel free to share them P.S. vodkaman hope you are still around
