Fulldraw84 Posted March 5, 2008 Report Share Posted March 5, 2008 Do any of you guys know were to get some guided cork drill bits? In the mudhole catalog there alittle to spendy for me. I heard harbor freight was a good place for stuff but cant find them Joe Quote Link to comment Share on other sites More sharing options...
Mattman Posted March 5, 2008 Report Share Posted March 5, 2008 I assume you mean the Flex Coat ones that are spade bits with a short section of rod on the tip? You can make your own. They sell a kit with the tips and you use your own spade bits. I bought the set of completed bits. Worth every penny. Quote Link to comment Share on other sites More sharing options...
thedude Posted March 6, 2008 Report Share Posted March 6, 2008 i read you can use a grinder to sharpen the backs/top of a paddle bit. Then slide the shaft of the bit through your cork and insert into a drill. Fire up the drill and pull the bit through. I have yet to try it, but i'm pretty dang close. Matt - where did you find the kit? Quote Link to comment Share on other sites More sharing options...
Mattman Posted March 6, 2008 Report Share Posted March 6, 2008 thedude said: Matt - where did you find the kit? I'd guess any Flex Coat distributor can get them for you. I bought my fully competed set of bits from Bingham Enterprises. Quote Link to comment Share on other sites More sharing options...
HookUp Posted March 15, 2008 Report Share Posted March 15, 2008 I bought mine by the piece to ease the pain of the price. For the size rods I build, all I need was three. If I get into bigger rods its jsut another $15-6 Quote Link to comment Share on other sites More sharing options...
