claye75 Posted May 4, 2008 Report Share Posted May 4, 2008 do you guys pour the molds full or do you allow for the expantion. thanks Quote Link to comment Share on other sites More sharing options...
Husky Posted May 4, 2008 Report Share Posted May 4, 2008 do you guys pour the molds full or do you allow for the expansion.thanks Fill ONE side with 16 lb density foam, after mixing thoroughly. That will be enough to fill the mold and then some. Be sure to keep the mold "snugged up" and be sure that it has proper venting to allow for pressure release and excess to escape. If its too tight the silicone will distort and w/o proper venting, the pressure will distort the casting. Placing the mold on a sheet of wax paper will save you clean up time. Quote Link to comment Share on other sites More sharing options...
rlcam Posted May 5, 2008 Report Share Posted May 5, 2008 Not trying to highjack a thread here,but where do you get the foam mix and what is it called exactly?Looks like something I would like to try..Robert Quote Link to comment Share on other sites More sharing options...
MTfishingrods Posted May 5, 2008 Report Share Posted May 5, 2008 Heres a good site to get it. Fiberglass , Epoxy , Composites, Carbon Fiber - U.S. Composites, Inc. Quote Link to comment Share on other sites More sharing options...
