CObasser Posted May 27, 2008 Report Share Posted May 27, 2008 I'm just getting started and have some ?'s about 2 part molds , do i always need to vent 2 part molds and if so where is the best place on the mold to do , im starting with 2 types , one is a stick bait , another is a beave type bait. Quote Link to comment Share on other sites More sharing options...
nova Posted May 27, 2008 Report Share Posted May 27, 2008 You shouldn't need venting for the stick. You probably will for the beaver. I would put a vent at the end of each "claw", and flipper. www.novalures.com Quote Link to comment Share on other sites More sharing options...
CObasser Posted May 28, 2008 Author Report Share Posted May 28, 2008 should it be done that way with any baits that have arms/flippers/etc. ? and how large of a hole should i try 1/8 " 3/16 " ? Quote Link to comment Share on other sites More sharing options...
nova Posted May 28, 2008 Report Share Posted May 28, 2008 1/8" should be fine. It's not necessary to do it for some baits but why take a chance. It's much easier to make vents as you make the mold instead of after it's dry and sealed. www.novalures.com Quote Link to comment Share on other sites More sharing options...
