mikemay Posted June 15, 2008 Report Share Posted June 15, 2008 Hi there guys I have been learning alot from here lately. I am currently using a small fluid bed and getting good results with single dipping jigs. I want to build a larger fluid bed thats is about 10inch by 10inch. Dose anyone have any experience building or using larger size fluid beds? Is it possible? Are there vibrating motors in them? I just can't seem to find anyone that has built a larger one any suggestions would be great. Thanks Quote Link to comment Share on other sites More sharing options...
dlaery Posted June 15, 2008 Report Share Posted June 15, 2008 I have one that is 12 x 16. I bought it from Component Systems. It has a vibrating motor. I did not like it. I couldn't keep the eyelets open on jigs, 1/4 oz thru 1-1/2 oz. The air flow was not consistant from side to side. I took it apart and divided the chamber into 2 compartments so I could adjust air flow on each side. This helped some but I think it would have worked better if it had 4 compartment instead of 2. Quote Link to comment Share on other sites More sharing options...
mikemay Posted June 15, 2008 Author Report Share Posted June 15, 2008 Dlaery thanks for the reply. I was a bit pestimestic if the larger ones would work good or not. I guess for high volume vinyl is the way to go Quote Link to comment Share on other sites More sharing options...
mikemay Posted June 15, 2008 Author Report Share Posted June 15, 2008 On another note dose any one paint jig eyes on with a air brush Quote Link to comment Share on other sites More sharing options...
