Source for wire bait keepers?

[AlvinMack]

I

[rr316]

Spinnerbait wire, .24 or higher (prefer .32) cut into 1- 1.5" lengths

[Spike-A-Pike]

There is a Member Submitted Tutorial in the Wire How-To forum titled "Making Consistent Screw Locks - Rev. 1.0" that was submitted by TU Club Member, Kelly.

While not exactly the same, the principles for making a screw lock could likely be adapted to making a bait keeper - assuming you intend to pour your own jigs. If you can explain in a bit more detail how you plan to employ the info, you may get a better response. Good luck and tight lines.

[reeves]

Mike,

I purchased 5,000 of them from Mustang Wire last year. They are rather easy to incorporate into your mold, just very tiny to handle. How many are you looking for? I may be able to help you with a few, but large quantities you will have to get from Mustang.

[AlvinMack]

Mike,

I purchased 5,000 of them from Mustang Wire last year. They are rather easy to incorporate into your mold, just very tiny to handle. How many are you looking for? I may be able to help you with a few, but large quantities you will have to get from Mustang.

Thanks Reeves!

5,000 may be a bit much unless I would be able to find someone to split the material with me, I had like 300 in mind. Does that mean that I better start to learn how to make my own as RR316 suggested?

[21xdc]

I too have bought from Mustang Wire co.. He does want bulk sales. I bought screw locks in a smaller coil diameter than offered to the public. He had 7 sizes of wire and coil diameters. I'm not sure if he has the barb that you are looking for, But I'm sure he would make some. Mustang Wire Products, Inc. - What's New