booneangler Posted December 22, 2008 Report Share Posted December 22, 2008 Just wondering what everyone uses to make there skirts. Post a pic or tell about it. Quote Link to comment Share on other sites More sharing options...
hollywood100 Posted December 25, 2008 Report Share Posted December 25, 2008 I bought mine from Jann's Netcraft. It is exclusive to them. It mounts with a thumbscrew to the edge of a table or workbench. I have had very good service from this product and if I needed to replace it, I would buy the same one. Hope this helps! Quote Link to comment Share on other sites More sharing options...
JSC Posted December 25, 2008 Report Share Posted December 25, 2008 Check out FishingSkirts.com ..Charlie has a good one. I have his and also the "Expander Pliars" with clamp on attachament ... I like Charlies. JSC Quote Link to comment Share on other sites More sharing options...
Long Lake Lures Posted January 11, 2009 Report Share Posted January 11, 2009 I agree with JSC. Charles' tool works well and is cost-effective (~$5). Dave Quote Link to comment Share on other sites More sharing options...
bamarocks Posted January 16, 2009 Report Share Posted January 16, 2009 i use a pc of an aluminum arrow and a practice tip. it is about 6 inches long and you can roll about 25 collars on it the use a pc of wire to pull your tabs in roll the collar off nad your done. got mine at an archery store here in town.they have pcs of broken arrows and didt charge me for the one i have and the tips are cheap too Quote Link to comment Share on other sites More sharing options...
HookUp Posted January 16, 2009 Report Share Posted January 16, 2009 Mine's similar to bama's. Except I use the bottom part of a ball point pen, and a piece of wire bent with a handle on one end and a hook on the other. Thread rubber onto pen, hook skirt, pull into pen housing, slide rubber down and secure. Quote Link to comment Share on other sites More sharing options...
