Swimbait

[RBelott]

I am a newbie to pouring soft plastics. I was wondering how to make a swimbait mold. Any advise will be greatly appreciated.

[Tman2]

First your going to need to read.

http://www.tackleunderground.com/forum/soft-plastics-how/13748-introduction-pouring-pastics.html

http://www.tackleunderground.com/forum/soft-plastics-how/15698-pouring-one-piece-mold.html

Then, some more...

http://www.tackleunderground.com/forum/soft-plastics-how/13945-pouring-stick-baits.html

http://www.tackleunderground.com/forum/soft-plastics/15424-make-your-own-mold.html?highlight=POP+mold

http://www.tackleunderground.com/forum/soft-plastics/15163-plaster-pop-mold.html?highlight=POP+mold

http://www.tackleunderground.com/forum/soft-plastics/15266-sealing-pop.html?highlight=POP+mold

http://www.tackleunderground.com/forum/soft-plastics/14723-baking-pop-mold.html?highlight=POP+mold

http://www.tackleunderground.com/forum/soft-plastics/14474-pop-mold-advice.html?highlight=POP+mold

http://www.tackleunderground.com/forum/soft-plastics/13785-pop-sealing.html?highlight=POP+mold

All the info you need is located on this site, but you'll have to do a little work. Everybody's helpful, but you can learn a lot using the search function. Good luck.