ROWINGADUBAY Posted May 28, 2009 Report Share Posted May 28, 2009 I made my first pop mold today and it turned out great then I made another the bottom turned out great but I ran out of pop and I think I poured it on to thin it is setting while I type I made the bottom about an inch thick I thought I had enough for the top but it is only about 1/4 inch thick by the cavity do you guys think I should start over or seperate the two halfs and just re-do the top part? Thanks for your help George Quote Link to comment Share on other sites More sharing options...
nova Posted May 28, 2009 Report Share Posted May 28, 2009 You don't need to start over. Just get more POP and pour it over the top of the thin one. You will need to make some indents and irregular marks in the thin POP before you pour the next layer. This will help with the bonding of the two halfs. Just be careful you don't go through the thin layer when you make the indents. (Take a pocket knife and put the point on the POP; then spin it like a drill. This will make a cone shape in the thin POP). That's how I make my line-up pins when I make a mold. www.novalures.com Quote Link to comment Share on other sites More sharing options...
