jim45498 Posted August 29, 2009 Report Share Posted August 29, 2009 I use a fine point sharpie for the sig. I sign, use the hair dryer for a few seconds (not on my hair, just the bait) wait a minute, then use the dryer again and put on the D2T. Never had a problem after heat setting it. I found it to be the simple way for me. Quote Link to comment Share on other sites More sharing options...
CL Rods Posted August 29, 2009 Report Share Posted August 29, 2009 Ok now that this post is officially off subject.. and all the NO FUN POLICE seem to not be on TU as much.. CHECK OUT THIS VIDEO!!! I found it today on the net.. dont worry it's clean.Christian Comedy Tim Hawkins.. ... Everyone needs to laugh and cry everyday. I was laughin so hard I cried. You were right, the video is very funny, even my wife thought it was funny! I wonder if he signed his worm! Never figured signing one would help me catch the fat ones. Quote Link to comment Share on other sites More sharing options...
foxbites Posted August 31, 2009 Report Share Posted August 31, 2009 Sharpie fine point markers work fine with d2t, but smear when you use etex. Quote Link to comment Share on other sites More sharing options...
seamsea Posted August 31, 2009 Report Share Posted August 31, 2009 Usually just monitor the going's on here but: I figured someone would chime in with color preserver for rod thread. So far I have not gotten any bleed with any pen unless I keep brushing it over and over. Not saying it won't run but I haven't made it yet except once I applied just after writing with a blue ballpoint and immediately brushing CP over and over. I did the same thing with just one brush and no bleed. I'm sure some of you build rods, surely you got some you can try. Academy has it if anyone is interested. I would be interested in the results since some of you seem to get to sign your name on a lot of baits. Quote Link to comment Share on other sites More sharing options...
spoopa Posted August 31, 2009 Report Share Posted August 31, 2009 To not get bleed in my signatures I just shoot some createx clear over the bait and I have no problems, its easy and thin.... and it also works to lol. Jacob Quote Link to comment Share on other sites More sharing options...
Lure--Prof Posted August 31, 2009 Report Share Posted August 31, 2009 Sharpie fine point markers work fine with d2t, but smear when you use etex. You'll find that this subject, and its solution was covered on page 3 of this thread a couple of times. Quote Link to comment Share on other sites More sharing options...
