brendandrage Posted January 12, 2010 Report Share Posted January 12, 2010 Hi all, I have several hundred 4" craw rib tubes i mis purchased from barlows and I was thinking that I may be able to remelt and remold them. Can anyone tell me if this is possible or should i just bin them? Thanks in advance Regards Brendan Quote Link to comment Share on other sites More sharing options...
daveh Posted January 12, 2010 Report Share Posted January 12, 2010 Hi all, I have several hundred 4" craw rib tubes i mis purchased from barlows and I was thinking that I may be able to remelt and remold them. Can anyone tell me if this is possible or should i just bin them? Thanks in advance Regards Brendan yes just have good ventilation. you can also add new plastic to them when remelting. try it don`t cost anything. may also add a little stabilizer. or sell them on ebay. Quote Link to comment Share on other sites More sharing options...
hawghunterbaits Posted January 12, 2010 Report Share Posted January 12, 2010 Yes most baits can be remelted. Most of your store brought baits ex: zoom, strike king, gy tend to smoke alot when remelting. Good ventilation is a must! GY baits tend to asorb and hold water at times so make sure the r good and dry. Good Luck. Quote Link to comment Share on other sites More sharing options...
flyingcross Posted January 18, 2010 Report Share Posted January 18, 2010 (edited) Yes most baits can be remelted. Most of your store brought baits ex: zoom, strike king, gy tend to smoke alot when remelting. Good ventilation is a must! GY baits tend to asorb and hold water at times so make sure the r good and dry. Good Luck. Just curious if anyone has tried melting down and reusing Strike King 3X plastics? Would they retain their durability and float ability? Edited January 18, 2010 by flyingcross Quote Link to comment Share on other sites More sharing options...
