catfish85 Posted February 14, 2004 Report Share Posted February 14, 2004 where can i find a mold for tube jigs so that i can mass produce them, i am dipping right now but that takes alot of time, i read that delmart was coming out with one, is it up yet thanks alot i hope you can help me Quote Link to comment Share on other sites More sharing options...
WidowMaker Posted February 14, 2004 Report Share Posted February 14, 2004 You can always make up more sets of dipping rods. Maybe you could make them with air hose couplings going to each rod so you could blow the tubes off the rods and lube them up and dip them again. Quote Link to comment Share on other sites More sharing options...
catfish85 Posted February 14, 2004 Author Report Share Posted February 14, 2004 what is the best way to make dipping rods and what kind of pot do you think is the best for dipping Quote Link to comment Share on other sites More sharing options...
WidowMaker Posted February 14, 2004 Report Share Posted February 14, 2004 I mostly make jigs so i dont know a lot about it other than what ive observed from watching someone dip their own. He used several small deep fryers to hold the plastic and had numerous dipping devices on hand. The dipping devices were built with seven rods mounted on a round base. Picture a clock face with one rod in the middle and the other six rods located at the 1:00, 3:00, 5:00, 7:00, 9:00, and 11:00 o'clock positions. He must have had several hundred of these devices on hand. Quote Link to comment Share on other sites More sharing options...
