Spraying D2t

[Fernet]

Morning,

I belive I have read somewhere here about airbrushing Devcon two tonner. But is that even possible considering the huge viscosity of the stuff? If so, what kind of airbrush would one need for the task?

[clamboni]

Morning,

I belive I have read somewhere here about airbrushing Devcon two tonner. But is that even possible considering the huge viscosity of the stuff? If so, what kind of airbrush would one need for the task?

You have to thin it. 3:1 with acetone works well. I used a peak x3 usually. Cheap 0.5 mm siphon feed brush. when I was only doing a couple baits I'd use a 0.3mm gravity feed......worked well enough. Just keep an eye on the needle cap......I used cheap brushes for it and the sloppy spray patterns caused it to build up on the tip a little.......once there's enough buildup, it'll splatter.

[clamboni]

You have to thin it. 3:1 with acetone works well. I used a peak x3 usually. Cheap 0.5 mm siphon feed brush. when I was only doing a couple baits I'd use a 0.3mm gravity feed......worked well enough. Just keep an eye on the needle cap......I used cheap brushes for it and the sloppy spray patterns caused it to build up on the tip a little.......once there's enough buildup, it'll splatter.

WOW.........I apologize, I just reread this post and realized I misread it the first time. I was talking about dick nite's. There's no way you'd be able to get devcon thin enough to spray while at the same time retaining any kind of strength.