ROWINGADUBAY Posted March 3, 2012 Report Share Posted March 3, 2012 My question is will uncured sculpey clay cause a two part platinum cure silicone to not set properly? Quote Link to comment Share on other sites More sharing options...
rixon529 Posted March 5, 2012 Report Share Posted March 5, 2012 Contact the mfr of the silicone you're using and ask them. Quote Link to comment Share on other sites More sharing options...
eric001 Posted March 5, 2012 Report Share Posted March 5, 2012 no, I do that to make swimbait hooks and harnesses- works great- the last rtv i bought was a 1:1 mix and set in an hr- fully cured overnight but ive poured lead/ plastic, resin for plastic lures and it works fine and you still retain detail. ive only made lead mold this way though Quote Link to comment Share on other sites More sharing options...
Smallie Posted March 7, 2012 Report Share Posted March 7, 2012 I remember something about clay with sulfer in it causing the problems with the rtv curring. Eric001 - are you saying you poured lead into uncured Sculpey molds? Quote Link to comment Share on other sites More sharing options...
quietfly Posted March 7, 2012 Report Share Posted March 7, 2012 I spoke with adam at smooth on today and sculpey is fine with there platinum sil products... I spoke with adam at smooth on today and sculpey is fine with there platinum sil products... Quote Link to comment Share on other sites More sharing options...
