yellowdawg Posted April 26, 2012 Report Share Posted April 26, 2012 got a spire piont mold but need larger eye holes to receive 1/2" eyes instead of the 9/32" eyes it calls for any advice on the easiest way to accomplish this. Don't really want to drill out each leadhead. Quote Link to comment Share on other sites More sharing options...
BLT Posted April 26, 2012 Report Share Posted April 26, 2012 Unless you can figure out how to make the post that forms the eye in the mold bigger, I don't see to many options. Wish I could help you out. Quote Link to comment Share on other sites More sharing options...
atijigs Posted April 26, 2012 Report Share Posted April 26, 2012 1/2 inch punch and 3-4 wacks with a hammer and you will be set. Quote Link to comment Share on other sites More sharing options...
mkvnmtr Posted April 26, 2012 Report Share Posted April 26, 2012 I believe you can make some 3-D eyes in place any size you like. If you do not wish to make them on the jig you can make them in the normal way and fill the hole with epoxy when you install them. Quote Link to comment Share on other sites More sharing options...
psv Posted April 26, 2012 Report Share Posted April 26, 2012 (edited) I'm OK wih the eyes size on this mold, but the wholes are too shallow and I couldn't find any better method that drill every whole a littlte deeper. It doesn't take too much time. Can live with it. Edited April 26, 2012 by psv Quote Link to comment Share on other sites More sharing options...
yellowdawg Posted April 26, 2012 Author Report Share Posted April 26, 2012 thnaks for the replys i may per able to do it with a forsner bit i think Quote Link to comment Share on other sites More sharing options...
