speechless33759 Posted May 21, 2012 Report Share Posted May 21, 2012 Hey guys, I've been experimenting with a resin pour with Microballoons. I'm using a 1:1 MB to hardener and 1:1 MB to resin ration. I'm not getting a good "Float" with the weights in, it'll hang sideways rather than straight up and down as I'd like. have any of you tried a higher ratio of MB to resin/hardener with success? Quote Link to comment Share on other sites More sharing options...
crankpaint Posted May 24, 2012 Report Share Posted May 24, 2012 IF your pouring along the back try pouring the lower half without the mb. and then adding them to the top half that would make the top lighter even more and might cure the prob. Quote Link to comment Share on other sites More sharing options...
Skeeter Posted May 26, 2012 Report Share Posted May 26, 2012 You need to send an PM to Coley. He is the best micro balloon person that I know. He has a ton of knowlege on the subject. Skeeter Quote Link to comment Share on other sites More sharing options...
