jwomac6 Posted July 7, 2012 Report Share Posted July 7, 2012 Will the Jann's Netcraft injector (says super-sport on the side) work with any other molds such as lurecraft, bears, etc.... Quote Link to comment Share on other sites More sharing options...
CrabbyBass Posted July 8, 2012 Report Share Posted July 8, 2012 Sorry, no. The Jann's netcraft injector does not hold enough plastic to inject an aluminum mold. When they are not falling a part, they work great for the plastic molds Janns sells and I also use them for the POP(plaster of paris) molds that I make. I have an injector from basstackle.com and it works great. I like that is has a locking pin on the nozzle to hold it in place while injecting. The aluminum injectors may be a little pricey, but well worth the cost. Quote Link to comment Share on other sites More sharing options...
jwomac6 Posted July 8, 2012 Author Report Share Posted July 8, 2012 Thanks for your help Crabby. I like the results that I have gotten from the Netcraft molds and injector, but I am looking for some different molds(specifically a creature bait like a brush hog). Do the hand poured molds like lurecraft and even the more expensive aluminum ones leave a flat side on one half of the baits, or does it produce a decent bait? Thanks to all in advance. Quote Link to comment Share on other sites More sharing options...
JSC Posted July 8, 2012 Report Share Posted July 8, 2012 "Do the hand poured molds like lurecraft and even the more expensive aluminum ones leave a flat side on one half of the baits, or does it produce a decent bait? Thanks to all in advance." Depends on your skill in pouring ... You do not want to over pour nor underpour .. a rounded off top side is desired .. Practice is the name of the game for open pour molds ... A lot of things (laminates and etc) can be done with this method. Quote Link to comment Share on other sites More sharing options...
JSC Posted July 8, 2012 Report Share Posted July 8, 2012 Bob .. I think you could but I don't think I would care for it (using Injector on open molds) I can see a lot of flow problems ... I am not good at pouring with a cup but with a presto with bottom valve you can really control the flow and that is where I see an injector would have problems ... I do both and see advantages for both depending on the lure configuration ... Years ago I could really turn them out with a "Wax Dropper" But the presto when used correctly is a little better. Quote Link to comment Share on other sites More sharing options...
