R Fry Posted October 8, 2012 Report Share Posted October 8, 2012 Just wondering if anyone has used the CS Coatings UV Seal Coating for their cranks. I found in on line doing a search and it looks like it would be pretty easy to use for the clear coat. Let me know. Thanks, RF Quote Link to comment Share on other sites More sharing options...
Cougarftd Posted October 10, 2012 Report Share Posted October 10, 2012 I have used it on a limited basis (about a dozen baits) ...dip and hang worked well...did not work well on my turner. High gloss hard finish...after 3 times out holding up well Quote Link to comment Share on other sites More sharing options...
fishmanmark Posted October 10, 2012 Report Share Posted October 10, 2012 I have been using it for about three years now on repaint's works fine.One thing i will say the longer you let it cure the harder the finish.I have only had to dip the bait's one time each which was nice.And as far as any yellowing not yet i have had a bait stuck up by my heater vent in my truck I for the life of me cant get out lol.It's been there little more than a year now and still looks good Quote Link to comment Share on other sites More sharing options...
Skeeter Posted October 11, 2012 Report Share Posted October 11, 2012 Where can you buy enough of this stuff to dip? I can only find small jars of it for sale. Skeeter Quote Link to comment Share on other sites More sharing options...
Matt Moreau Posted October 11, 2012 Report Share Posted October 11, 2012 Looks like its waterbased. Anyone tried the submersion test? Quote Link to comment Share on other sites More sharing options...
Nathan Posted October 11, 2012 Report Share Posted October 11, 2012 Skeeter...good to hear from you!...If you call the manufacture direct you can buy it in larger quantities ...Nathan Quote Link to comment Share on other sites More sharing options...
Skeeter Posted October 11, 2012 Report Share Posted October 11, 2012 Thanks Nathan. Skeeter Quote Link to comment Share on other sites More sharing options...
willowblade Posted October 13, 2012 Report Share Posted October 13, 2012 The CS Coatings seal coat and UV blast seal coat can both be used on crankbaits. You can either dip the lure into the seal coat and hang it to dry, or you can brush it on in several thin coats and build it up slowly. Both finishes will produce a durable, crystal clear finish on your lures. Seal Coat UV Blast Seal Coat Quote Link to comment Share on other sites More sharing options...
bobv Posted October 13, 2012 Report Share Posted October 13, 2012 Did not pass the submersion test for me, it turned cloudy over night. Easy to use and easy to clean just not for me. Quote Link to comment Share on other sites More sharing options...
Matt Moreau Posted October 16, 2012 Report Share Posted October 16, 2012 Ya from the looks of what i could find it seems like just another poly Quote Link to comment Share on other sites More sharing options...
toadfrog Posted October 17, 2012 Report Share Posted October 17, 2012 Seal coat needs to be cured for not less than 24 hrs. before hitting the water . I generally put anything from CS under infrared heat . at least 115 degrees circulated air . If you are going to use this type of coating I reccomend investing in an OSHA approved vapor mask. Quote Link to comment Share on other sites More sharing options...
