Arkansaskiller247 Posted June 10, 2013 Report Share Posted June 10, 2013 I was just thinking is there any way that you could take a stencil and vacuum form it to a 3d object that is bigger on the end that is in the middle of the bait. Insert that into a two piece cranking mold and pour the crankbait material alumilite makes over that. Wait for It to set up and then vacuum out the stencil? I think it would work but have some others around me that think it wouldnt. Thoughts or ideas on how I could do this would be GREATLY appreciated. Quote Link to comment Share on other sites More sharing options...
bluetickhound Posted June 10, 2013 Report Share Posted June 10, 2013 You'll never know til you try... I imagine if you make a setup and it doesn't work right you'll learn enough to get it right sooner rather than later. Quote Link to comment Share on other sites More sharing options...
