basscat39 Posted December 1, 2013 Report Share Posted December 1, 2013 How do you guys separate the round rubber after its tied to the jig? I've tried to pull it at a angle but it doesnt separate well or slides thru the wire. Thanks Quote Link to comment Share on other sites More sharing options...
Jig Man Posted December 1, 2013 Report Share Posted December 1, 2013 Quote Link to comment Share on other sites More sharing options...
Big-D Posted December 1, 2013 Report Share Posted December 1, 2013 Pull it and cut it under tension as seen in Jig Man's picture. If it is slipping under the wire when you pull it, the wire is not tight enough. -D Quote Link to comment Share on other sites More sharing options...
cadman Posted December 1, 2013 Report Share Posted December 1, 2013 I see Jig Man beat me to it. I was going to tell you to PM Jig Man. He is the only one that I know of that posted this picture years ago and it works. I got the tip from Jig man and use it to this day. Quote Link to comment Share on other sites More sharing options...
