grundlman Posted January 14, 2014 Report Share Posted January 14, 2014 I need to temporarily modify one of my molds to make some custom prototypes. I have tried the poly clay and it will not harden up. Anyone have any suggestions? I would like to be able to use it then use a dremel or scraper to get it out of there. Thanks Jason Quote Link to comment Share on other sites More sharing options...
gone2long Posted January 14, 2014 Report Share Posted January 14, 2014 High temp silicone Quote Link to comment Share on other sites More sharing options...
smalljaw Posted January 14, 2014 Report Share Posted January 14, 2014 JB Weld High Temp Epoxy Putty, I use it to make weed guard slots smaller and to eliminate collars on small jigs.Once you are done with it you can usually just pop it out but I know my 1 mold I used it the epoxy popped out after 23 pours so I just put it back in but it isn't hard to get out. Quote Link to comment Share on other sites More sharing options...
Jig Man Posted January 14, 2014 Report Share Posted January 14, 2014 We discussed this once before. Just be sure not to use the regular JB Weld. It will stay forever. Since that discussion I have used the epoxy putty to get rid of some collars. It seems to be working just fine. (Thanks to smalljaw.) Quote Link to comment Share on other sites More sharing options...
grundlman Posted January 14, 2014 Author Report Share Posted January 14, 2014 Thanks for the help guys. I am guessing I can get the jb weld putty at Wally world? Quote Link to comment Share on other sites More sharing options...
Jig Man Posted January 14, 2014 Report Share Posted January 14, 2014 I may have gotten mine at Lowe's. It has been a long time and I don't remember. Quote Link to comment Share on other sites More sharing options...
