begs Posted May 20, 2014 Report Share Posted May 20, 2014 Saw that do it mold has had a crankbait sealer, also have it in UV anyone try this yet, just ordered the uv sealer, going to give it a shot see how it works. Let me know if you tried it what are your thoughts. Quote Link to comment Share on other sites More sharing options...
HAWGFAN Posted May 20, 2014 Report Share Posted May 20, 2014 If this is the stuff by CS Coatings, I've experimented with it a little. I'm not sure it's as tough as some other finishes. I put a thin layer on jig heads, then a coat of D2T for extra durability. I've considered trying it on a crank. That's the closest thing I could find on the Do It website. You may be referring to another product. Quote Link to comment Share on other sites More sharing options...
begs Posted May 20, 2014 Author Report Share Posted May 20, 2014 http://www.jannsnetcraft.com/Search/seal%20coat.aspx Here is the link to what I was talking about, might have helped before Quote Link to comment Share on other sites More sharing options...
HAWGFAN Posted May 20, 2014 Report Share Posted May 20, 2014 Don't put the UV type on too thick. It will cure to a cloudy blueish haze. That's one reason I recommend another clear coat over it. It is easy, cleans up quick, and dries fast. I just can't speak for how it would stand up to rocks when used for cranks. My guess is not very well. I have used it to clear up the opaque sanded areas on new crank bills, and it works good for that. It scratches, like anything will in that application, but I've never saw it peel. I don't dip coat my lures like some do, so that gives me an easy way to make bills look nice on new molded plastic baits. If you have a line tie hanger that's loose in a new bill, it seems to also do a good job of seeping into any voids and tightening it up. That saves some tuning headaches. Quote Link to comment Share on other sites More sharing options...
