Chip Posted July 12, 2004 Report Share Posted July 12, 2004 Guys... a great way to make stencils is: I use a dremel on a dremel drill press stand. I use a Dremel #107 engraving cutter. I then draw my image on thick plastic sheets... (A milk jug works great if you dont have access to plastic sheets) Draw your image on the plastic and then use the engraver to mill out the design.... I then take some sand paper to deburr the plastic stencil I have made by laying the sheet of plastic flat and running a sanding block over it until all that is left is a clean stencil.... Try it! It works great!!! Chip Quote Link to comment Share on other sites More sharing options...
Tally Posted July 13, 2004 Report Share Posted July 13, 2004 Thanks Chip- How clean and sharp are the edges? Tally Quote Link to comment Share on other sites More sharing options...
Chip Posted July 13, 2004 Author Report Share Posted July 13, 2004 Very Sharp~! Lay your substrate on a flat surface and lightly sand away the burrs and the image will appear in the stencil with nice clean edges. Chip Quote Link to comment Share on other sites More sharing options...
