BuckMaxx Posted December 11, 2014 Report Share Posted December 11, 2014 I have a drop shot mold that I took a little too much meat off with the dremel. What do I use to repair it? Can I use JB weld or some other sort of synthetic metal polymer? Thanks!! Quote Link to comment Share on other sites More sharing options...
smalljaw Posted December 11, 2014 Report Share Posted December 11, 2014 JB Weld works great!! Quote Link to comment Share on other sites More sharing options...
dlaery Posted December 11, 2014 Report Share Posted December 11, 2014 I have had good luck with JB weld. Make sure the aluminum is clean. don't try to sand too soon, make sure it is fully cured. Quote Link to comment Share on other sites More sharing options...
BuckMaxx Posted December 12, 2014 Author Report Share Posted December 12, 2014 Thanks wasn't sure if it would melt or give off fumes. I'll get after it Quote Link to comment Share on other sites More sharing options...
LimpNoodle Posted December 13, 2014 Report Share Posted December 13, 2014 I have a mold that one of the aluminum handles broke off. JB Weld didn't work worth a darn for that poor mold. Quote Link to comment Share on other sites More sharing options...
