jackg Posted February 1, 2015 Report Share Posted February 1, 2015 anybody know how to restore lips that turn yellow Quote Link to comment Share on other sites More sharing options...
mark poulson Posted February 1, 2015 Report Share Posted February 1, 2015 If it's surface yellowing, a quick dip in acetone should remove it. If it's yellow all the way through, I haven't found a way to remove it. Quote Link to comment Share on other sites More sharing options...
BobP Posted February 2, 2015 Report Share Posted February 2, 2015 If the lip was covered with a topcoat at the factory, it can yellow over time - just like on the paint where you don't notice it as much. If you are afraid acetone might eat up the plastic, you can also sand off the topcoat, smooth it with 400 or higher grit paper, then recoat the lip with new topcoat like MCU, concrete sealer, or lacquer (don't use epoxy) to make the sanding marks disappear. If the plastic itself has yellowed, you're out of luck. Quote Link to comment Share on other sites More sharing options...
hazmail Posted February 2, 2015 Report Share Posted February 2, 2015 Try a kiss---sorry Jackg, couldn't resist that. Pete Quote Link to comment Share on other sites More sharing options...
Nathan Posted February 2, 2015 Report Share Posted February 2, 2015 Boo...That was REALLY bad Pete..lol..Nathan Quote Link to comment Share on other sites More sharing options...
