Kennyfore Posted June 18, 2015 Report Share Posted June 18, 2015 Is there a better resin for jointed swim baits (screw eye/pin method) than alumilite or smooth on, etc. looking for a tough resin. The above mentioned may be tough enough. Just wondering if there was anything else out there. Thanks Quote Link to comment Share on other sites More sharing options...
hazmail Posted June 18, 2015 Report Share Posted June 18, 2015 Ken---- I think I might be stating the obvious, but how about ''Devcon 2 Ton'', it's pretty strong, there is a heap of tests etc on here. Pete Quote Link to comment Share on other sites More sharing options...
Kennyfore Posted June 18, 2015 Author Report Share Posted June 18, 2015 I'm talking about the resin that the whole bait is made of. I do use a lot of Devon 2T for various uses. I have silicone rubber molds and was wondering if there was a tougher resin Quote Link to comment Share on other sites More sharing options...
token12 Posted June 19, 2015 Report Share Posted June 19, 2015 You could look into casting epoxy resin http://www.smooth-on.com/Castable-Epoxy-Res/c1295/index.html but will probably sink like a brick. Quote Link to comment Share on other sites More sharing options...
hazmail Posted June 21, 2015 Report Share Posted June 21, 2015 Sorry Ken, thought you were looking for a resin tho glue in hinges etc. Pete Quote Link to comment Share on other sites More sharing options...
