Musky0503 Posted August 4, 2015 Report Share Posted August 4, 2015 I'm trying to decide which way I want to mount my Hagens Could you please post pictures of your mounted wireformer? Thanks a lot Quote Link to comment Share on other sites More sharing options...
Zib Posted August 4, 2015 Report Share Posted August 4, 2015 My bender is not currently mounted so I can't post a pic. All I did was drill 2 holes through my computer desk (old desk) that lined up with the holes in the base of the bender & made sure that there was enough room for the bottom handle to make a complete 360 degree turn without hitting the underside of the desk. I only have it bolted down while I'm bending wire then remove it to make room to do other things. Quote Link to comment Share on other sites More sharing options...
Apdriver Posted August 4, 2015 Report Share Posted August 4, 2015 I use mine at home and in my shop at my bench. I mounted mine on a piece of furniture grade 3/4 inch plywood and use a C clamp to attach it to my workbench or table depending on where I want to work. If I want to do 2 or 3 hours work in the evening and visit with the Mrs. It's nice to have it portable. 1 Quote Link to comment Share on other sites More sharing options...
LimpNoodle Posted August 4, 2015 Report Share Posted August 4, 2015 My Twistech is mounted to a piece of 1" x 4" across the 4" end. Then I clamp the piece of wood to the table. Once I get the new bench built I'll have holes drilled in the bench so I can bolt the piece of wood to the bench. Quote Link to comment Share on other sites More sharing options...
