emptystringer81 Posted August 12, 2015 Report Share Posted August 12, 2015 Was just wondering what everyone uses to keep their injector working smoothly, I wanted to oil the o rings but not sure what oil is ok to use. I'm a mechanic and I do know that when you add o ring lube it can shrink certain I rings Quote Link to comment Share on other sites More sharing options...
edgecrusher Posted August 12, 2015 Report Share Posted August 12, 2015 Was just wondering what everyone uses to keep their injector working smoothly, I wanted to oil the o rings but not sure what oil is ok to use. I'm a mechanic and I do know that when you add o ring lube it can shrink certain I rings Personally I use worm oil, scent or WD40, the first two should be fine, others may disagree with the WD40 Quote Link to comment Share on other sites More sharing options...
Walking Dead Posted August 12, 2015 Report Share Posted August 12, 2015 PAM 1 Quote Link to comment Share on other sites More sharing options...
Ccfish Posted August 13, 2015 Report Share Posted August 13, 2015 I always spray worm oil in the injector then use the rod to push a paper towel through it to clean out all the little pieces of plastic left in it. Quote Link to comment Share on other sites More sharing options...
Bassinjunkie88 Posted August 13, 2015 Report Share Posted August 13, 2015 I use a tad of WD-40 before I start every time. Quote Link to comment Share on other sites More sharing options...
emptystringer81 Posted August 14, 2015 Author Report Share Posted August 14, 2015 thanks guys, I have some pam at home ill try that Quote Link to comment Share on other sites More sharing options...
Jig Man Posted August 15, 2015 Report Share Posted August 15, 2015 I keep a bottle of cooking oil on the work bench top. I dip my plungers in it before I begin and again later if needed. I also use it to coat molds that have been setting around for a while. Quote Link to comment Share on other sites More sharing options...
fishon-son Posted August 16, 2015 Report Share Posted August 16, 2015 pam kitchen spray for cooking is the best and cheap to 1 Quote Link to comment Share on other sites More sharing options...
Big Ray Posted August 28, 2015 Report Share Posted August 28, 2015 I know that this is late and you probably already took the other guys advice. I am going to tell you what I use anyway. Petroleum jelly. When I bought my injector for Baitjunkys that is what the note that came with it said to oil up the o ring with. Quote Link to comment Share on other sites More sharing options...
fishon-son Posted August 28, 2015 Report Share Posted August 28, 2015 that might work but who wants there fingers full of jelly....im not tooting my horn but pam is the way to go...cheap easy and no mess or clean up...you can even use the off brand..couple shots down the tube and your ready to get to work......thats it..... 1 Quote Link to comment Share on other sites More sharing options...
Geegeebaits Posted September 2, 2015 Report Share Posted September 2, 2015 Worm oil is perfect. Quote Link to comment Share on other sites More sharing options...
camrynekai Posted September 4, 2015 Report Share Posted September 4, 2015 Is oiling required by certain injector manufactures? I haven't had any issues with my ultra molds twin injector and it has 1000's of shoots under its belt using 70/30 plastic salt mix. Just curious. Quote Link to comment Share on other sites More sharing options...
