dchance Posted December 7, 2015 Report Share Posted December 7, 2015 looking at trying a single strand mono or fluoro weedguard. question is, with the mold weedguard pins being about 1/8 inch thick, how do you glue in a smaller diameter guard like a thick mono or fluorocarbon? Quote Link to comment Share on other sites More sharing options...
Basseducer Posted December 7, 2015 Report Share Posted December 7, 2015 Try to make a pin out of some round stock to match the diameter of the line you want to use. Quote Link to comment Share on other sites More sharing options...
dchance Posted December 7, 2015 Author Report Share Posted December 7, 2015 didn't think of that, thanks. now to find what to use for a pin Quote Link to comment Share on other sites More sharing options...
rustedhook Posted December 7, 2015 Report Share Posted December 7, 2015 Use a small nail and insert it in a skirt band. Stop the skirt band flush with the top of the mold cavity and extend the nail. This will create a hole to glue in your weed guard. Quote Link to comment Share on other sites More sharing options...
dchance Posted December 7, 2015 Author Report Share Posted December 7, 2015 rustedhook I'm not following you. Quote Link to comment Share on other sites More sharing options...
rustedhook Posted December 7, 2015 Report Share Posted December 7, 2015 I'm guessing you are pouring a jig head that you want to use something smaller than a 1/8 inch weed guard. The skirt band takes the place of the base hole pin. The hole in the skirt band will allow you to insert a small nail the size of the mono, floro you want to use as a weed guard. Stop the band even with the top of the cavity and extend the nail into the cavity. Pour you jig head and pull the nail out. That will be the hole for your weed guard. Hope this helps 1 Quote Link to comment Share on other sites More sharing options...
dchance Posted December 7, 2015 Author Report Share Posted December 7, 2015 yes it does. thanks for clarifying! Quote Link to comment Share on other sites More sharing options...
