Curt - NC Posted December 16, 2015 Report Share Posted December 16, 2015 Hey gang, there's a free webinar for airbrushing tomorrow! Be sure to check it out here! http://luremakingclassroom.com/custom-lure-painting/?ap_id=lpo 1 Quote Link to comment Share on other sites More sharing options...
fishon-son Posted December 17, 2015 Report Share Posted December 17, 2015 thanks 1 Quote Link to comment Share on other sites More sharing options...
Vodkaman Posted December 17, 2015 Report Share Posted December 17, 2015 I have signed in too, just for a looksee. Dave 1 Quote Link to comment Share on other sites More sharing options...
Curt - NC Posted December 17, 2015 Author Report Share Posted December 17, 2015 Hope you guys like it Quote Link to comment Share on other sites More sharing options...
Musky Glenn Posted December 17, 2015 Report Share Posted December 17, 2015 I'll be watching. Quote Link to comment Share on other sites More sharing options...
DaBehr Posted December 18, 2015 Report Share Posted December 18, 2015 I found the Webinar very informative. ..has anyone taken the painting class he was promoting? Quote Link to comment Share on other sites More sharing options...
Vodkaman Posted December 18, 2015 Report Share Posted December 18, 2015 I fell asleep - certainly not because of the content of the webinar, but I had been up all night. The last I remember is the paints section. Most unfortunate really, I was sat here clutching my HP-C plus, waiting for the action to begin. I will certainly pick it up from the replay layer on. Although I have not painted with an airbrush before, after 8 years on TU, I have read just about everything on the subject. I was looking forward to the actual painting part. I know there are plenty of vids on the internet to learn with, and when I gather enough enthusiasm on the subject, I will watch them. But, at the moment, I have nothing to paint anyway. I have just started work on a 4" four section lipless perch. The plan is for a hollow resin, to achieve close to neutral buoyancy. I had better get my calculations right, as this one is going from CAD straight to mold. I was thinking that this would be a good project to finally get some painting done, if it swims of course. Dave Quote Link to comment Share on other sites More sharing options...
Travis Posted December 18, 2015 Report Share Posted December 18, 2015 I had trouble getting on. I used the link sent via email and it loaded up and gave me a "presenter hasn't started the presentation" message and stayed on the board. At that same time my computer went to deathly slow and unable "resolve host". I spent the following two hours getting things going again. Will have to check out the replay. Quote Link to comment Share on other sites More sharing options...
Vodkaman Posted December 18, 2015 Report Share Posted December 18, 2015 Travis - yes, there were problems at the start for everyone, probably for about ten minutes or so. It was resolved and after that it all went smoothly. A very good presentation I might add, particularly worth watching for those just getting started. Dave Quote Link to comment Share on other sites More sharing options...
DaBehr Posted December 18, 2015 Report Share Posted December 18, 2015 Has anyone taken his course? Quote Link to comment Share on other sites More sharing options...
jhackett Posted December 20, 2015 Report Share Posted December 20, 2015 Haven't taken his course but did buy his ebooks which seem very informative. Quote Link to comment Share on other sites More sharing options...
