omartinjordan Posted April 22, 2016 Report Share Posted April 22, 2016 I'm in the process of designing a mold and would like to know if anyone has dimensions for the injector hole. Diameter, taper angle, etc? Quote Link to comment Share on other sites More sharing options...
Frank Posted April 22, 2016 Report Share Posted April 22, 2016 5/8" is pretty much standard. Taper or depth is up to you. Quote Link to comment Share on other sites More sharing options...
majic man Posted April 22, 2016 Report Share Posted April 22, 2016 .630 .500 deep Quote Link to comment Share on other sites More sharing options...
big worm Posted April 23, 2016 Report Share Posted April 23, 2016 I make mine as deep as posible, so when plastic cools you have enough plastic there for the draw back and not have to go back and top off your plastic. 1 Quote Link to comment Share on other sites More sharing options...
rayhorse Posted April 27, 2016 Report Share Posted April 27, 2016 (edited) 5/8", you may consider a runner diameter bigger than your bait diameter. Edited April 27, 2016 by rayhorse Quote Link to comment Share on other sites More sharing options...
