Slammingjack Posted November 7, 2016 Report Share Posted November 7, 2016 I see these on Barlow's. Look to be about the same cost as ec570's. Anybody used these or tried them? Quote Link to comment Share on other sites More sharing options...
21xdc Posted November 7, 2016 Report Share Posted November 7, 2016 I tried them years ago... They were really sharp, thin wire, and quality controll was weak. There were always some bad hooks in each batch. They bent open really easy. After I bought several batch's and saw a pattern, I went another direction. They may have stepped up since then.. Quote Link to comment Share on other sites More sharing options...
cadman Posted November 8, 2016 Report Share Posted November 8, 2016 I had the same experience as 21xdc. I will not use them, I had too many defects. JMO Quote Link to comment Share on other sites More sharing options...
Darkman Posted November 8, 2016 Report Share Posted November 8, 2016 X3 super sharp but never knew which ones where going to break o bend Just not worth getting, heat treating and annealing were suspect Quote Link to comment Share on other sites More sharing options...
Slammingjack Posted November 9, 2016 Author Report Share Posted November 9, 2016 Thank you guys! Won't waste money on them. Quote Link to comment Share on other sites More sharing options...
