wallyc14 Posted March 2, 2017 Report Share Posted March 2, 2017 I ordered one of the 5 inch molds and have a question for those who have this mold. What do y'all do to seal up the tail once you remove the insert? Thanks in advance. Quote Link to comment Share on other sites More sharing options...
Walking Dead Posted March 2, 2017 Report Share Posted March 2, 2017 I have a couple of different molds that have holes that I use a soldering iron/gun to touch and hold together. Quote Link to comment Share on other sites More sharing options...
wallyc14 Posted March 2, 2017 Author Report Share Posted March 2, 2017 Thanks w d ! What about lams will it do 2 colors Quote Link to comment Share on other sites More sharing options...
Walking Dead Posted March 2, 2017 Report Share Posted March 2, 2017 Wally, I do not have this mold but a couple of others that have holes. I suspect with the correct tools it will laminate. Quote Link to comment Share on other sites More sharing options...
wallyc14 Posted March 2, 2017 Author Report Share Posted March 2, 2017 The sprue is a long sweeping 90 degree bend I guess I'll try with my prolam and see what happens. Thanks again wd Quote Link to comment Share on other sites More sharing options...
Frank Posted March 3, 2017 Report Share Posted March 3, 2017 I had this mold many years ago and it will laminate just try and keeep the temp of the plastic as low as you can with slow even pressure. Some mixing will happen but it won't be bad. Quote Link to comment Share on other sites More sharing options...
wallyc14 Posted March 3, 2017 Author Report Share Posted March 3, 2017 Thanks frank I tried it last night and your 100% right it does mix a little but no biggie Quote Link to comment Share on other sites More sharing options...
