squigster Posted April 29, 2017 Report Share Posted April 29, 2017 Hey All, I need to transfer some old Chemionics to a different container so that I can cut open the original container so that I can scrape out the hard pack to remix it. I am thinking about a 5 gallon bucket and adding a ball valve to the bucket but I am worried the buckets curvature may be a problem with sealing it good enough when I drill a hole for the ball valve. I figured a 5 gallon bucket would be much easier to remix alos in the future. Any thoughts on this? or have you guys done anything similar? Any thoughts would be appreciated. Thanks! Quote Link to comment Share on other sites More sharing options...
wallyc14 Posted April 29, 2017 Report Share Posted April 29, 2017 I have taken a spout for a Colman cooler( bought it separately at dicks sporting goods) and put it in a wide mouth one gallon jug that I had laying around and it works good for me, I would think you could do the same with a bucket. I used no sealant on it. It came with a gasket and it doesn't leak . I can take a pic later. I just take the lid off and loosen up the hard pack on the bottom and put it back in service Quote Link to comment Share on other sites More sharing options...
bryanmc Posted April 30, 2017 Report Share Posted April 30, 2017 (edited) I used to buy some plastic on ebay that came in 2 gallon buckets. I'd just use a cup to dip it out as needed until it got low enough to easily pour from the bucket. Edited April 30, 2017 by bryanmc 1 Quote Link to comment Share on other sites More sharing options...
