Lucky777 Posted June 12, 2017 Report Share Posted June 12, 2017 I know there are glass rattles (worm rattles) that have a sharp point on one end that you can insert into a soft plastic lure. I've seen a few big name (saltwater) companies that have rattles already in them and was curious as to if anyone here knew how they did it? Do they have special inserts for their aluminum molds that they have to reload every time? Does anyone have a picture of they way they do it? Thanks. Just curious on the process. Quote Link to comment Share on other sites More sharing options...
Pointbreakfish Posted June 16, 2017 Report Share Posted June 16, 2017 Hi. I do the same with my paddle tail lures. It's as simple as placing the rattles in the mold before injecting. It means they sit in the tail section but that is fine. I'll then double dip the tail in clear to give a little extra strength. Cheers. Quote Link to comment Share on other sites More sharing options...
Bamafan2277 Posted June 16, 2017 Report Share Posted June 16, 2017 I take my knife and put a drop of plastic in the mold where I want the rattle then set the rattle while its hot then close the mold and inject. That way its surrounded with plastic. 3 Quote Link to comment Share on other sites More sharing options...
