probass Posted August 4, 2017 Report Share Posted August 4, 2017 Need Pouring Pots For Open Molds Quote Link to comment Share on other sites More sharing options...
Travis Posted August 4, 2017 Report Share Posted August 4, 2017 (edited) How much you want to spend. Can order from the usual places but it is very easy to make your own that is more than adequate. Presto pot, drill, brass valve/fittings. Overhead stirrer from McMaster Carr, shaft coupler, shaft, riveter, brass flange sleeve bearings, knobs, and sheet metal for stirrer. You will also need a hardwood board, angle iron, etc.. to make a top to span the presto pot and support/affix the stirrer to and appropriate tap and dies. While mine isn't near as nice as many out there but has been in use before they were being sold and was near 100 bucks including tap/die stuff I bought to thread the shaft and other odds and ends. I think could would have been closer to 75 if I wanted not to fidget. Edited August 4, 2017 by Travis Quote Link to comment Share on other sites More sharing options...
probass Posted August 4, 2017 Author Report Share Posted August 4, 2017 Pot capacity is too large but great idea thank you Travis Quote Link to comment Share on other sites More sharing options...
