robbor Posted November 28, 2017 Report Share Posted November 28, 2017 Anyone try making a silicone or other diy mold on really small plastics? I can do molds with metal master but not really small plastics 1/2" to 1.5". Quote Link to comment Share on other sites More sharing options...
Anglinarcher Posted November 28, 2017 Report Share Posted November 28, 2017 Yes, I have done a silicone mold for small plastics. The key to remember is that plastisol is thick enough that it does not like going into the small cavities so you either need to use a squish type mold or inject. I did a squish type where you over fill then put the second half on (or allow the mold to close if you are using a one piece squish) and have it squeeze out. Hope this helps some. The following might give you some hints. http://www.makelure.com/store/pg/54-How-To-Videos.aspx#prettyPhoto/117/ 1 Quote Link to comment Share on other sites More sharing options...
jackie55 Posted December 3, 2017 Report Share Posted December 3, 2017 Have tried also.eaiser and cheaper to order from lurecraft. Quote Link to comment Share on other sites More sharing options...
Roger Linnell Posted December 3, 2017 Report Share Posted December 3, 2017 what are you trying to make? Quote Link to comment Share on other sites More sharing options...
