Modifying a do-it mold

[aulrich]

Actually it's not really a mod it's making it like the version I should have bought.

I bought the do-it  Shad jigging spoon with out the top hook hanger, so I am at the point where I want to make the mold I have look like this one.

https://store.do-itmolds.com/Shad-Bait-LurebrSz-34-1-1-12brHk-35517-or-3551brCollar-NA_p_998.html

I do have the bigger version of this mold and the insert slot is just cut into one side , it's hard to judge from the picture but I think the same may be true for the smaller since the insert wires are a much lighter stainless steel vs brass.

Also what sort of dremel head to do this job.

Part of me is wondering about putting a router bit into my drill press and slowly cutting a flat bottomed hole.

At this point I am open to suggestions.

 

 

 

[Apdriver]

What you are in search of is called a flat end mill. It will make the mod nice and won’t walk and run like a dremel. So much better. They are some pricey as any fine tool but not too bad. You need to know what size is needed as they come in many sizes but if you have the part you want to fit, that’s easy. Measure across the eye, leave a little room and go from there.

[m.t.pockets]

You can  just tape the eye in the position you need, close the mold and place the mold  in a vice. close the vice and it should leave an impression which will accommodate your needs