Looking for this grub mold

[robalo01]

This is a 5" grub. The tail and body are more narrow that I have been able to find on the usual sites. Does anybody know of an injection mold for this grub?

NOTE: I have seen a lot Fat Albert and Kalin grubs. I am looking for this more sleek model in particular. I think it was slod a while back by a "Wally Whale"  brand, but I am not sure about that.

Edited March 31, 2018 by robalo01

[Uncle Arnies Tackle]

9 hours ago, robalo01 said:

This is a 5" grub. The tail and body are more narrow that I have been able to find on the usual sites. Does anybody know of an injection mold for this grub?

NOTE: I have seen a lot Fat Albert and Kalin grubs. I am looking for this more sleek model in particular. I think it was slod a while back by a "Wally Whale"  brand, but I am not sure about that.

I don't know of one - but thanks for posting this - I was thinking my grub needed some more tail action after fishing it today. Might have to draw something up like this in solidworks.

 

 

[edgecrusher]

Try Rupert at ultra molds, sure there’s is like this

[robalo01]

On 4/1/2018 at 7:29 PM, edgecrusher said:

Try Rupert at ultra molds, sure there’s is like this

The design is right, but it only goes up to 3". I need 4.5-5"

[edgecrusher]

3 hours ago, robalo01 said:

The design is right, but it only goes up to 3". I need 4.5-5"

 

Send him a message, they will make it - I’ve seen them make the grub in huge sizes before.

if I recall they had10 inch at one stage!

[ute]

There is a picture of a very similiar 4 cavity grub mold on their site. Check the grub page.