robbor Posted August 30, 2018 Report Share Posted August 30, 2018 What’s the norm / best was to segment a wood lure body preferably with a v cut? I just got my duplicator for my mini lathe and am anxious to start on lures. Quote Link to comment Share on other sites More sharing options...
blackjack Posted August 30, 2018 Report Share Posted August 30, 2018 Radial arm saw and a jig to hold the bait while it is being cut Quote Link to comment Share on other sites More sharing options...
mark poulson Posted August 30, 2018 Report Share Posted August 30, 2018 You can use a table saw, too, with a jig. The main thing you need is a way to keep your round blanks properly oriented, so the cuts will be symmetrical and parallel to the center line of the blank. Round things like to rotate when they're being cut. Quote Link to comment Share on other sites More sharing options...
AZ Fisher Posted August 30, 2018 Report Share Posted August 30, 2018 If I understand the question correctly, I use a band saw. If your talking about the hinge joint on say an MS Slammer? I make a wooden swimbait rat. After turning the body on the lathe, I leave the square of wood on each end of the body. First it goes to the table saw to have the lipslot cut and then to the band saw to make the 90* joint cut. No jig required. Then cut off the two ends and you have your two body halves with the cuts made. I make the cuts when it's in the square form on the left. If I misunderstood, my apologies. 2 Quote Link to comment Share on other sites More sharing options...
robbor Posted August 31, 2018 Author Report Share Posted August 31, 2018 Thanks for the reply AZF, that’s exactly what I’m doing. First run will be balsa rats lol. I did recently see a vid as you did and leave the square wood on. Thanks for the reply! I’m sure I’ll have more questions later as I go from step to step. Now I need a table saw, lol. I still have to figure out the bills, resin, and forms. I’m wanting to do one piece forms slitted into the body just in case the balsa body fails on a big fish. Quote Link to comment Share on other sites More sharing options...
stretcher66 Posted September 25, 2018 Report Share Posted September 25, 2018 use poplar Quote Link to comment Share on other sites More sharing options...
aulrich Posted September 27, 2018 Report Share Posted September 27, 2018 Basswood and cedar are other good woods at least for floaters. Quote Link to comment Share on other sites More sharing options...