Anyfish Posted February 18, 2019 Report Share Posted February 18, 2019 New to the site, but looking for some advice. Trying to decide between the do it bullet head or ultra minnow spinnerbait molds. I like the look of the ultra but read a lot about pouring difficulty. I have tried and tried to find something (good or bad) on the bullet head. Thanks. Quote Link to comment Share on other sites More sharing options...
cadman Posted February 18, 2019 Report Share Posted February 18, 2019 Are you referring to bullet head spinnerbait mold or bullet head jig mold. If it is the bullet head spinnerbait mold, then I would get the ultra-minnow spinnerbait mold. BTW welcome to TU. 1 Quote Link to comment Share on other sites More sharing options...
Anyfish Posted February 18, 2019 Author Report Share Posted February 18, 2019 Yes spinnerbait molds in both cases. Thanks for the reply. Quote Link to comment Share on other sites More sharing options...
cadman Posted February 18, 2019 Report Share Posted February 18, 2019 Just now, Anyfish said: Yes spinnerbait molds in both cases. Thanks for the reply. If you use somewhat soft lead maybe a 70/30 mix 70 being soft, you shouldn't have any problems pouring. However if you have never poured before, there is a big learning curve. Read as much as you can about pouring and lead safety as you can on this forum. 1 Quote Link to comment Share on other sites More sharing options...
Anyfish Posted February 18, 2019 Author Report Share Posted February 18, 2019 I have poured jigs and soft baits for a while, just expanding out to spinnerbaits. Thanks again Quote Link to comment Share on other sites More sharing options...
