Joelh831 Posted November 5, 2019 Report Share Posted November 5, 2019 Hey guys looking for advice on what’s the best tool that won’t break the bank but get the job done. I need to make some wire through forms for some slow fall jigs and they have to be pretty damm close so they fit the mold. What do you guys recommend for a tool and I really don’t want to use pliers so is their something out their. Ps for some reason I haven’t been able to load up any photos 1 Quote Link to comment Share on other sites More sharing options...
LimpNoodle Posted December 8, 2019 Report Share Posted December 8, 2019 I use a Twistech for my wire needs. However making forms with one is pretty damn hard. You would need to start with a wire form made on the bender and work from there. Quote Link to comment Share on other sites More sharing options...
Kdog Posted December 10, 2019 Report Share Posted December 10, 2019 make your own. sounds smart assed, but its probably the best way. Realistically, the first one I made was a daunting task, took about 2 hours, After making the first one, others take 25 to 45 minutes, There is a post buried somewhere in the archives I used the information made mine from some 1/2" thick 1 1/2" wide aluminum plate. And have two bending arms, lay my wire in, get it oriented, Bend the first end, then the second and remove from bender. I made mine for the 3 sizes of CC forms I use. I also made one for the tail spin mold 1 Quote Link to comment Share on other sites More sharing options...
